1.2 GHz ID-1) which makes use of the available general-use low-speed portion of the DV data stream. Icom placed a GPS reporting capability in all of the VHF and UHF D-STAR ® radios (not included in the.I pretty quickly figured out that I needed a new OPC-478U cable and some software. Of course this meant that I needed to look into how to do this without punching a lot of buttons on the rig. I recently obtained an ICOM V8000 rig from a fellow ham and decided to change the channel programming that he had been using to match that of my other rigs.I wanted to be able to use the remote software for voice and switch over to remote desktop to do digital. That is how I ended up using the two conections. These setting are incompatible with RS-BA1 and cannot be changed remotely. Then back one level and set baud rate to 9600.Menu Button ->SET ->Connectors>CI-V>CI-V USB Port and link to remote.If the application is already installed and your try to install again withoutĮxplicitly deleteing it you get this obscure message: RS-BA1 Remote Control Software - Quick Reference Guide Cannot access Radio.' the solution is as follows: If I set it to anything other than 4800 9600 or 19200 it will give 'Communication failed. The RS-BA1 Ver 2.10 has a 'Connect Setting' Tab. Radio set to 115200, port set to 115200 and it will only comment at 9600. The application and documentation can be downloaded from here:Ī purchased licence key is required to activate the RS-BA1 application.Ĭhanged USB cables, update the cp2101 driver to the latestġ0. -> 'Yes' to the second yellow screen - Must hold this for a ssecond or two or the update will not start.The Release Notes indicate upgrade to the following levels: On the radio -> Menu Button -> Set Tab -> etc. It can help calibrate a sound card to a time signal and do frequency measurement Today: CW, PSK, MFSK, RTTY, Hell, DominoEX, Olivia, and Throb are all supported. RTTY Decode Baud Rate -> 9600 (greyed out)įldigi is a modem program for most of the digital modes used by radio amateurs Wsjt-x Vers 2.1.0 Settings Software setup on Linux:ĬI-V USB to REMOTE Transceive Address -> 00h VK4PK - Icom IC7300 Icom IC7300 Icom Support

Icom 7300 software downloads